10ft Curved (Tube Frame)

Simply unpack the case and assemble the aluminum frame.  Unfold fabric display and slip over the aluminum frame and zip up. Fabric stretches taught and then lift into place.  Sounds easy and it is easy.

Uses:  Can be used as a trade show backdrop, step and repeat backdrop, in store display, etc.  Better than a pop up panel system and much less expensive.  New graphics can be printed for use on the existing frame.

Travels easy

Round frame tubes are 1-1/4" in dia.

Fabric is sewn like a pillowcase and simply slips over the frame and is attached under the frame with a zipper.

The fabric is stretchy and when pulled tight eliminates all the wrinkles.

Set Up Time - 15min - 1 person,  less than 10 min with 2 people

This 10' x 8'  display wall can be set up by 1 person although 2 people is preferred.  Total set up time for 1 person is about 15 min.  Straight pole sections are bungeed together and attach to the corners.  Joints are all numbered, so just match the numbers and set up will be quick.  Slipping the fabric over the frame is easiest with 2 people working together, but 1 can do it.  Once the fabric is over the frame you tension the fabric by zippering the bottom under the bottom bar (easiest if the frame is laying down)

About the Fabric Used in this Tube Display Frame

Your graphic will be printed on a lightweight polyester stretch fabric using a dye sublimation process in which the threads of the fabric are dyed during the printing process. 400-degree heat is used on the fabric and ink in order to dye the threads giving you a vibrant, full color, long lasting print.

To clean your display fabric we recommend washing on a cold water, gentle cycle setting with a color friendly detergent. You can either air dry or tumble dry on a low-temperature setting in the dryer.

If your fabric gets wrinkled or creased from folding it's an easy fix. Generally, the stretch fabric eliminates any creases when pulled taught over the frame.  The fabric can also be steamed to look good as new. 

About the Display Frame

The frame is made of 1-1/4" dia aluminum tube.  Very lightweight at about 10lbs.  Breaks down into approx 2' sections which are bungee corded together for easy setup.  Sections snap together with snap pins.  No tools are needed to erect this frame and it would take 1 person less than 10 minutes to assemble.  All the joints are numbered for easy assembly, simply match up the numbers and you will be done in no time.

About the Lights

Lights are 18w LEDs on an arm that sticks out from the frame.  The lights are attached with a "C" type aluminum clamp on the bar of the frame.  Typically you would want at least 2 lights on this 10' frame, 3 is better and 4 will get you noticed.  This frame type is difficult to add lights to both sides if you have a double-sided graphic since there is really no place to run the wires along the top of the display.

more about the lights

more about the hard carry case

Need it Faster?

We have an option to get your project to print faster than our normal turnaround.  How it works - Once you approve your proof we will put you on a 24hr print path, which means we will get your project ready to ship within 24hrs.